Questions? 800-523-5874 | [email protected]
These new correlative microscopy coverslips (CMC's) are not designed to replace the glass or quartz coverslips, which have superior optical properties, and so are far better for fluorescent microscopy. The CMC's are designed to satisfy the needs of correlative microscopy where an initial, general analysis is performed using light or fluorescent microscopy and then the specimen is further processed for analysis by SEM, TEM or cryofixation.
If you need to perform detailed analysis using fluorescent microscopy, then the CMC's are not the solution. If, however, you want to perform a comprehensive analysis using different analysis techniques, then the CMC's are the only solution. The key advantage of the CMC's is that they are made on special film that can be cut or punched (for cryo applications), something that is not possible with glass coverslips. The grid image is also transferred to any embedded specimen making cell location far easier.
Because this is new technology, it often requires a change in the customer's preparation method. The method that the customer has traditionally used for glass coverslips may not be suitable for these film ones.
The key thing to successful use of these CMC's seems to be the type of resin and the preparation. We have already mentioned about the need to ensure a hermetic seal between the Beem capsule and the CMC film. The preparation works perfectly with low viscosity epoxy resins (e.g. Spurr, EPON). Sufficient polymerization is obtained in 24 hours at 60°C – it does not normally require 48 hours.
This can be done either with UV light or alcohol. After using alcohol it is best to immerse the coverslip in polysyline to give better adhesion (just using alcohol can leave the surface 'too clean and too smooth').
The CMC's are made on a special polyester base film which is 0.18mm thick. There is no absolute tolerance specified on the thickness of the film.