French Flag   chineseFlag   japaneseFlag   germanFlag   SpanishFlag   argentinaFlag   mexicoFlag   russianFlag

View Cart || Request a 2017 Catalog

Electron Microscopy Sciences

Technical Data Sheets

Polyester Wax

EMS Catalog #19312

Electron Microscopy Sciences Catalog

Introduction

A ribboning embedding medium with a low melting point

Polyester Wax is a synthetic wax devised by Dr. H. F. Steedman, Department of Zoology, University of Glasgow; (now at Bath University of Technology), as a ribboning embedding medium (Nature, 1957, 179 1345). Its main advantage over paraffin wax and ester wax is its low melting point (37°C), which results in the reduction of tissue hardening and shrinkage, and obviates the use of infiltration ovens.

The wax is soluble in most organic solvents, including alcohols, ethers, esters, ketones and hydrocarbons; warming to 25°C facilitates solution. The wax has good water tolerance, is almost opaque, and sections easily. No electrification of ribbons occurs during cutting. Sections of 2 microns and more may be cut at room temperatures between 10 degrees to 22°C.

Infiltration

It is essential that the wax solvent should be entirely removed from the specimen.

Because of the low melting point of the wax the speed of the usual processes of solvent removal, evaporation and diffusion into wax is much reduced. and heavy non-volatile solvents such as cedar wood oil are not recommended unless some means of stirring is employed during infiltration. Recommended solvents are alcohols, ethers and esters or, if preferred, xylene or ligroin. A mixture of 96 parts of ethanol and 4 parts of water is considered excellent.

Fixed specimens are brought to the ethanol/water mixture or to ethanol absolute, "Cellosolve" or xylene as preferred. The specimen may be immersed in a mixture of any of the above solvents and wax, or in pure wax. The time allowed for infiltration is about 33% longer than that for paraffin wax.

Block-making

The block is prepared by the usual method, as for paraffin wax blocks. and should be left to cool without immersing the molten wax in water. It is unnecessary to surround the blocks with cold water during the setting time.

Section Cutting

Sections should be cut at a speed of about 80 to 100 a minute-similar to that used in paraffin wax sections. As the wax melts at approximately the same temperature as that of the body the block should not be handled. As mentioned in the introduction, sections of 2 microns and more may be cut at a room temperature of 10 degrees to 22°C.

Note: As polyester wax tends to become softer the longer it is kept in a molten condition, it is recommended that only a sufficient quantity for a day's use be melted at one time. The main stock of wax for block making can thus be kept solid until it is required.

Online Ordering

Polyester Wax is available online from the EMS Catalog. For ordering or product information, click here.